A-Plus Paints | Paint Products Manufacturers and Suppliers in Philippines

A-Plus® NC Lacquer Water White Clear is a premium Nitrocellulose-based, clear silky clear gloss lacquer finish that dries to a hard, durable, and protective film. It enhances the natural grain of wood. It is ideal for interior sealed wood such as furnitures, fixtures, cabinets, doors, panels, and many more.

☑Premium Fast-Drying Lacquer-Based Varnish
☑Silk-Gloss High Build Coating
☑Smooth, Dust-Free Finish
☑Superior Durability and Adhesion
☑Resists Cracking and Peeling
☑Easy to Use, Lead-Free

Category: Woodcraft and Varnishes Tag: Nitrocellulose Lacquer Based Coatings

Specifications

Principal Uses: For interior sealed wood such as furnitures, fixtures, cabinets, doors, panels, and many more.

Sheen: Eggshell

Coverage: 25-30 square meter per gallon / coat

Surface Dry: 10 minutes

Recoat Interval: 30 minutes

Dry Through: 1 hr

Thinning and Clean Up: A-Plus® PG Lacquer Thinner

Application: Brush or Spray

Packaging: 1L, 4L

Surface Preparation & Precautions

Ensure wood material is fully kiln dried/treated.
If previously painted, strip off all loose and chalking paint with A-Plus Supertanggal® Paint Remover. If necessary, remove wood discoloration by applying A-Plus® Wood Bleach #1 & #2.
Sand surface smooth to eliminate surface imperfections. Correct surface imperfections using A-Plus® NC Lacquer Spot Putty or A-Plus® Fast-Drying Plastic Wood Filler.
Surface to be applied on must be thoroughly cleaned, free of any contaminants that can affect adhesion such as wax, oil, grease, moisture, and loose particles.
Avoid painting under extreme environmental conditions and/ or bad weather conditions.

Painting Procedure

New Wood:

Sealer Coat: Apply at least 2 coats of A-Plus® NC Lacquer Sanding Sealer. Sand lightly(#220/#440) before topcoat application. Allow at least 1 hr drying before putty.
Stain (Optional): Apply A-Plus® Penetrating Wood Stain using either brush or spray.
Putty: Correct surface imperfections (especially for open grain wood) using A-Plus® Fast-Drying Plastic Wood Filler. If necessary, tint with A-Plus® Penetrating Wood Stain. Allow to cure for at least 2 hours before sanding and applying another coat of A-Plus® NC Lacquer Sanding Sealer then sand again.
Final coat: Apply at least 2 coats of A-Plus® NC Lacquer Water White Clear. Perform sufficient sanding in between each coat.

Repainting:

Strip off old paint using A-Plus Supertanggal® Paint Remover. If old lacquer finish is in good condition, sand surface.
Apply at least 2 coats of A-Plus® NC Lacquer Sanding Sealer. Sand lightly(#220/#440) before topcoat application. Allow at least 1 hr drying before putty.
Make sure surface is clean and dry before applying at least 2 coats of A-Plus® NC Lacquer Water White Clear.

(Note: 10% by volume of A-Plus® PG Lacquer Flo is added to the varnish mixture just before application to prevent moisture blushing)

A-Plus® NC Lacquer Water White Clear

Specifications

Surface Preparation & Precautions

Painting Procedure

New Wood:

Repainting:

Related products

Login